Installation and wiring of solar LED street lamp controller

LED solar street lamp controller is an important part of solar LED street lamp. At present, the mainstream LED solar street lamp controller adopts intelligent constant current controller and intelligent multi-mode switch control. It's a solar street lamp central accessory. Pay attention to the following problems during installation:
1. After the battery is connected, the indicator light of the controller is running water. (the positive and negative poles are reversed, and the controller does not work)
2. After the load is connected, press the "adjust" button three times continuously to adjust the time and the load is connected. (the load is not short circuited, otherwise the controller is damaged)
3. The load is not on. Please check the load or measure the battery voltage.
4. After connecting the photocell, the load is turned off, indicating that the light control is normal. Otherwise, please check the photocell.
Test phase:
(1) If everything is OK, the green light is always on.
(2) If the battery voltage is too low, the red light is always on.
(3) If the photocell has no voltage, the yellow indicator is always on.
Note: general solar street lamp controller will be equipped with wiring diagram. The specific wiring method shall be consistent with the wiring diagram marked on the controller. Otherwise, the solar street lamp controller will not work or work normally.